Fingertec Face ID 2 Installation Guide User Manual download pdf

Back Plate

4 feet / 1.2 meter

(recommended)

TCP/IP PORT

POWER

ADAPTER

PORT (A)

RS232/RS485 SERIAL PORT

USB PORT

ACCESS

CONTROL

PORT

ALARM PORT

Wiegand OUT RS232

RS232

cable

RS485

485-

485+

GND

TXD

RXD

GND

WD1

WD2

3rd party controller

with 26 bits wiegand

input

RX+

RX-

1. RS485 Single Connection

RS232/RS485

Data Converter

RX+

RX-

RS232/RS485

Data

Converter

2. RS485 Network Connection

485+

485-

485+

485-

485+

4851

GND

+12V

DC12V 3A

Power Supply

POWER SUPPLY (B)

Door Lock connector. Refer to Appendix I

Step 1

Determine the Location and Positioning

of the Installation

•

Avoid installing the terminals in locations that has contact with

a strong light source (e.g direct sunlight, spotlight, fluorescent

light, etc)

• Avoid installing the terminals in locations with high moisture or

condensation levels in the air

• The recommended installation height of the terminal from the

ground is 1.2 meter.

Step 2

Mounting of Terminals on A Wall

• After determining the height of the terminal from the ground

level and have made the relevant marks on the wall, drill the

screws into the wall to hang the back plate.

Refer to Appendix II for dimensions and measurements of instal-

lation.

Installation Guide

www.fingertec.com

Face ID2

Face & Fingerprint Recognition for

Time Attendane & Door Access Control System

INSTALLATION TIPS:

Best installation location of Face ID 2

must

1 - Avoid sunlight.

2 - 2 meters away from any light source i.e.

ceiling direct flourescent light

3 - Suggested 1.2m from the ground level

(measure from ground to the face captur-

ing camera)

Step 3

Wiring for Power Supply

1. Use the power adapter provided in the package and insert the

power adapter to the port marked A in the diagram.

2. Use power cables (black and red) to connect to a linear power

supply with specifications of 5VDC 3A (Marked B).

1 2 3

Summary of Contents

Page 1 - Installation Guide

Back Plate4 feet / 1.2 meter(recommended)TCP/IP PORTPOWER ADAPTER PORT (A)RS232/RS485 SERIAL PORTUSB PORTACCESS CONTROL PORTALARM PORTWiegand OUT RS23

Page 2

DOORLOCKTIMERStep 4Setting Up Data Communications (Skip this step if you are using USB  ash disk to transfer data)The data communication ports are p

Page 3 - Front View of Back Plate

Diagram1 • Normally Close (NC) Diagram 2 • Normally Open (NO) Diagram 3 • Other Accessories NO2COM2NC2SENGNDBUTNO1COM1NC1GND+12VRelease ButtonEM Lock

Comments to this Manuals

No comments

Fingertec Face ID 2 Installation Guide User Manual

Browse online or download User Manual for Equipment Fingertec Face ID 2 Installation Guide. FingerTec Face ID 2 Installation Guide User Manual

Summary of Contents

Comments to this Manuals

Related products and manuals for Equipment Fingertec Face ID 2 Installation Guide