Fingertec m-Kadex Installation Guide User Manual download pdf

m-Kadex

Step 1

Determine the Location and Positioning

of the Installation

•

Avoid installing the terminals in locations with high moisture or

condensation levels in the air

• The recommended installation height of the terminal from the

ground is 1.2 meters.

Step 2

Mounting Terminals on a Wall

•

After determining the height of the terminal from the ground

level and have made the relevant marks on the wall, drill the

screws into the wall to hang the back plate.

Refer to Appendix II for dimensions and measurements of instal-

lation.

Step 3

Wiring for Power Supply

The power input ports for these models are located at the rear of

the terminals. There is no adapter plug supplied with the models,

instead you need to source for power cables (red and black cables)

to connect the power from the terminal to the AdapTec.

AL-

AL+

COM

BUT

GND

SES

BELL+

BELL-

RJ45-1

RJ45-2

RJ45-3

RJ45-6

J12

WDO

WD1

GND

RXD

TXD

GND

485A

485B

GND

+12V

V3.6 - 09032

USB

Port

Back Plate

4 feet / 1.2 meter

(recommended)

BEEP

GLED

RLED

INWD0

INWD1

GND

+12V

Wiegand

Power

OUT

3rd party

controller with

26-bits wiegand

output

RJ45-1

RJ45-2

RJ45-3

RJ45-6

WD0

WD1

GND

RXD

TXD

GND

485+

485-

TCP/IP

Wiegand

OUT

RS232

RS485

3rd party controller

with 26-bits wiegand

input

RS232

cable

TCP/IP

RX+

RX-

1. RS485 Single Connection

RS232/RS485

Data Converter

485B

485A

RX+

RX-

RS232/RS485

Data

Converter

2. RS485 Network Connection

485B

485A

485B

485A

GND

+12V

DC12V 3A

Power

Supply

Door Lock connector.

Refer to Appendix I

Installation Guides

www.fingertec.com

m-Kadex

Card Reader for Time Attendance &

Door Access Control System

1 2 3

Summary of Contents

Page 1 - Installation Guides

m-KadexStep 1Determine the Location and Positioning of the Installation• Avoid installing the terminals in locations with high moisture or condensatio

Page 2

Step 4Setting Up Data Communication (Skip this step if you are using USB  ash disk to transfer data)The data communication ports are positioned at t

Page 3 - Door Lock Connectors

Diagram1 • Normally Close (NC) Diagram 2 • Normally Open (NO) Diagram 3 • Other Accessories EM Lock (NO) + ---Emergency Break 1Glass (Type NO) 3Over

Comments to this Manuals

No comments

Fingertec m-Kadex Installation Guide User Manual

Browse online or download User Manual for Equipment Fingertec m-Kadex Installation Guide. FingerTec m-Kadex Installation Guide User Manual

Summary of Contents

Comments to this Manuals

Related products and manuals for Equipment Fingertec m-Kadex Installation Guide